Any,

This is a different problem. I thought, from Alex’ reply, that you were only interested in some patches.

The problem is the iO table itself. I experienced the same problem in the past and had to send the table in for repair. The problem I was having was that, the arm would repeatedly read the same rows, over and over, until it stopped reading the whole chart with an error message.

My suggestion is to send it in for repair. Or try your chart on another unit, if you can.

Best / Roger

From: eci-en-bounces@lists.callassoftware.com [mailto:eci-en-bounces@lists.callassoftware.com] On Behalf Of Anandaramakrishnan Srinivasan
Sent: 8 octobre 2010 04:42
To: eci-en@lists.callassoftware.com
Subject: [ECI-EN] Measuring test chart using profilemaker measure tool and i1io

Dear All

I am trying to measure a custom test chart using i1io and Profilemaker Measure tool.

The problem is the test chart contains some text in it. When i1io reads the chart, the data is transfered to the measure tool. Whenever the measuring head measures the text, some problem occurs and the data transfer is stopped. The measuring head quits measuring and Measure tool says "Too many measurement errors". I used the custom chart option in measure tool to measure this chart. Then, I created a reference file and tried. Same error occured.

I am trying to find out whether there is a way to tell the measure tool and i1io to skip certain patches and measure only the necessary patches. Is there any way, I can put some command in the reference file and say measure only these paches and skip these patches. I hope that I am clear. Please help me in this

Best Regards

Anand